Of these, only IEC 529 (European Community Specification) and JIS2-8 (Japanese Industry Standard) have graduated test levels. These two specifications are very similar, but IEC 529 is gaining more acceptance in Europe which is a major market for many US manufacturers and is more defined in terms of the actual test. The table below gives a summary of the requirements for IEC 529 for WATER PROTECTION PROVISIONS.
Level Definition
0 Non protected, No special protection
1 Protected against falling water Equivalent to 3-5mm rainfall per minute for a duration of 10 minutes. Unit is placed in its normal operating position.
2 Protected against falling water when tilted up to 15 degrees. Same as (1) above but unit is tested in 4 fixed positions - tilted 15 degree in each direction from normal operating position.
3 Protected against spraying water, Water spraying up to 60 degrees from vertical at 10 liters/min at a gage pressure of 80-100kN/m2 for 5 min.
4 Protected against splashing water. Same as level 3 but water is sprayed at all angles.
5 Protected against water jets Water projected at all angles through a 6.3mm nozzle at a flow rate of 12.5 liters/min at a gage pressure of 30kN/m2 for 3 minutes from a distance of 3 meters.
6 Protected against heavy seas. Water projected at all angles through a 12.5mm nozzle at a flow rate of 100 liters/min at a gage pressure of 100kN/m2 for 3 minutes from a distance of 3 meters.
7 Protected against water immersion. Immersion for 30 minutes at a depth of 1 meter.
8 Protected against water submersion The equipment is suitable for continuos submersion in water under conditions which are identified by the manufacturer.
*Note: IEC 529 level 7 is designated "IPX7" and is equivalent to JIS 7.
The position of "X" being left blank indicates that the unit has no special mechanical protection.
