Hello all,
Yesterday I was using my ED82 and was swapping eyepieces' back and forth. Well when I went to put my 30X mc on for the last time I gave it a good twist to make sure it was snug.
When I did that it seemed to turn just a little more than before. I went to twist it off and noticed the whole tube that it threads into was starting to turn with the EP.
So I turned it back to where it was and held the tube and the EP spun off no problem. It seems to work just fine with "normal" torque and I don't try and tighten the hell out of it.
So Should I be concerned about this. The tube only moved back and forth about 1/8 of a turn. Would this break the seal on the optics? Will this get worse overtime? Please ease my pain. thanks
Yesterday I was using my ED82 and was swapping eyepieces' back and forth. Well when I went to put my 30X mc on for the last time I gave it a good twist to make sure it was snug.
When I did that it seemed to turn just a little more than before. I went to twist it off and noticed the whole tube that it threads into was starting to turn with the EP.
So I turned it back to where it was and held the tube and the EP spun off no problem. It seems to work just fine with "normal" torque and I don't try and tighten the hell out of it.
So Should I be concerned about this. The tube only moved back and forth about 1/8 of a turn. Would this break the seal on the optics? Will this get worse overtime? Please ease my pain. thanks