dwever
Well-known member
This past weekend we spent significant time on the Flagler Beach Pier (pic 2) and in Ormond Beach (pic 1), Florida, and of course the salt air required more frequent cleaning. So I used the same technique I've always used with my Zeiss Mariners.
I am seeking comments regarding methodology as as I am concerned about protecting the coatings?
1. high volume but low pressure water from a hose to remove loose grit and film for a total of about twenty seconds.
2. Pop open in sequence 3 Zeiss alcohol foil wrapped disposable lens cloths. One for each 42mm objective lens and the third for both eyepiece lenses.
3. Very gently wipe using additional disposable lens cloths as necessary.
Did an advanced search on cleaning binoculars saw below:
My practice is essentially the same as Kammerdiner/Mark's. I avoid over cleaning. The key is to remove any silicaceous or other hard dust/grit and to dissolve any salt crystals before doing any serious wiping. Make sure you don't clean using a dirty microfiber cloth or lens pen or other device that may have accumulated grit that can scratch your lens.
When it is required in the field, some water or a lick, followed by a gentle drying (rub only if necessary) with microfiber (or more often a clean corner of my fleece/synthetic (microfiber equivalent) shirt is all I do.
At home, it is strong blower bulb and clean brush, followed by thorough wetting with water or isopropanol+water or ethanol+water or water+ammonia on a clean natural cotton ball, followed by drying/wipe with clean cotton ball and a bit of breath condensation. Persistent gunk (rare) gets ROR treatment and removed with Kimwipe.
I am seeking comments regarding methodology as as I am concerned about protecting the coatings?
1. high volume but low pressure water from a hose to remove loose grit and film for a total of about twenty seconds.
2. Pop open in sequence 3 Zeiss alcohol foil wrapped disposable lens cloths. One for each 42mm objective lens and the third for both eyepiece lenses.
3. Very gently wipe using additional disposable lens cloths as necessary.
Did an advanced search on cleaning binoculars saw below:
My practice is essentially the same as Kammerdiner/Mark's. I avoid over cleaning. The key is to remove any silicaceous or other hard dust/grit and to dissolve any salt crystals before doing any serious wiping. Make sure you don't clean using a dirty microfiber cloth or lens pen or other device that may have accumulated grit that can scratch your lens.
When it is required in the field, some water or a lick, followed by a gentle drying (rub only if necessary) with microfiber (or more often a clean corner of my fleece/synthetic (microfiber equivalent) shirt is all I do.
At home, it is strong blower bulb and clean brush, followed by thorough wetting with water or isopropanol+water or ethanol+water or water+ammonia on a clean natural cotton ball, followed by drying/wipe with clean cotton ball and a bit of breath condensation. Persistent gunk (rare) gets ROR treatment and removed with Kimwipe.
Attachments
Last edited: